Honeywell Commercial Security – Wireless Products Accessory Transmitters, Modules and Converters RP – View product information, features. : Honeywell Security RP Ademco Alarm Wireless Repeater: Home Improvement. The Honeywell RP is a wireless repeater module that boosts the radio frequency (RF) signal between a Honeywell wireless device and a wireless receiver.
|Published (Last):||9 December 2016|
|PDF File Size:||7.43 Mb|
|ePub File Size:||20.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
If needed locate the other wireless devices in their final. Add to my manuals Add.
Specifications – Honeywell ADEMCO RP Installation Instructions [Page 2]
Doesn’t that kind of defeat the purpose of the repeater? October 15, October 13, Wireless Repeater Extends the range of Series wireless devices Receives alarm, status and control messages from RF devices and repeats these messages to the control panel via the primary receiver Compatible with all wireless devices including bidirectional, House ID devices UL Listed for residential burglary AC powered with a six-hour battery back up.
You have no items in your shopping cart. Push, release, then hold down the tamper switch admco the. The Site ID is a factory-assigned, unique serial. The think you most need to look at it the current power draw of the panel and will adding this bring down the total admeco out.
Honeywell RF Wireless Repeater Module
The yellow LED should blink on when messages are sent. Temporarily disconnect the power source and battery from the. I ended up buying the transformer for the RP so this isn’t going to be an issue anymore.
5080rp again for your input.
See the Setting the Site ID section for details. Features Extends the range of series of wireless devices Receives alarm, status and control messages from RF devices, and repeats these messages to the control panel via the primary receiver Compatible with all wireless devices including bi-directional devices UL residential burglary listed AC powered with a six-hour battery back up back up battery included Tamper protected Key Benefits Provides extended coverage, reduces labor costs, saves installation time Saves wire run to a secondary receiver 5800pr a remote location Eliminates the need to upgrade to a control panel that support two receivers NOTE: ZT 8, hr Aux.
The Site ID provides many more. Some wireless devices e. The system simply shut down.
The RP features a Spatial Diversity system that virtually eliminates the possibility of “Nulls” and “Dead Spots” within the coverage area.
Note that removing the cover also places the RP in.
1 Honeywell & Ademco 5800RP Wireless Repeater Module
Comments to this Manuals Your Name. There’s a handy “Auxiliary Device Current Draw Worksheet” in the install manual that list the current for some common devices.
For easy identification of these messages, program alpha. If the LED does not turn off, repeat the. When prompted, toggle the tamper switch to enroll the serial. Page of 4 Go. Don’t have an account? Honeywell Wireless Security Products.
Write Your Own Review You’re reviewing: Honeywell Miscellaneous Security Products. Honeywell Wireless Security Systems.
I finally moved the RP to my detached garage closer to the trouble transmitter and am going on 2 weeks with no trouble. Normally on lighted when power AC or battery is. Status is sent whenever a change occurs or as part of a supervisory check-in message sent approximately once an hour.
I figure the battery powered transmitter was having trouble sending a strong enough signal and by moving the AC powered repeater closer, it was able to boost a good signal. To print the manual completely, please, download it. Certain wireless devices, such as theuse a “Site ID” instead.